Pull up a few feet of carpet and fold it over.
Rip up carpet how hard is it.
Keep pulling back the carpet and slicing it into strips.
Carpeting is a thick heavy material that requires a lot of effort and strength to remove.
Carpet is much easier to cut from the back than from the front.
One way to do this is to lift the carpet away from the floor as you cut.
Roll or fold the strip secure with duct tape and remove it from the room.
If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife.
Of carpet and cut it into easy to handle strips photo 1.
Start by pulling up the carpet.
Once the carpet is up it is not going to be very pretty.
Use a sharp new blade in your utility knife and be careful not to slice into baseboard or walls.
Use a utility knife with a sharp new blade to cut through the carpet backing.
Fold back about 3 ft.
With this goal in mind here are some things to consider before ripping up your carpet.
Remove this small piece of carpet and then pull up on the larger section.
If there s no need to save the carpet it is easier to cut the carpet into smaller sections with a utility knife and move the sections out one at a time.
Your carpet is held down with tack strips.
Even though you are probably eager and excited to finally see your hardwood floors underneath please push down your excitement and take this step slow.
Pulling up carpet is a relatively easy task although when rolled up a carpet can be very heavy bulky and difficult to move.
Start at one corner of your room and try to pull up the carpet.
Be aware the project generates quite a bit of dust and could spread out over two or three days but your ultimate reward will be a great looking wood floor that enhances the beauty of your home.
Carpeting is big heavy and bulky lincon says and just the act of pulling it up is more difficult than it might seem at first for starters carpeting attaches to the floor along the edges.
Keep both hands on the knife to avoid cutting a free hand.
If it won t come up then cut a small 6 inch by 6 inch square in the corner with your utility knife.
Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.